A homeowner in Burbank, CA, called us to service their garage door. When we inspected the door, it was apparent that the garage door tracks were out of alignment. That left a large gap between the garage door rails and the door. The homeowner also said they had frequent repairs to the garage door because it would abruptly close now and then. It turned out that the tracks were not properly reinforced during installation. We suggested putting additional reinforcement brackets that could help prevent damage and misalignment. We set the garage door repair along with the request for the insulation installation a few days later. The client feels safer and stress-free now that their garage door is more reliable with the stronger support and insulation installed. It was another successful garage door repair project by Fixxed Garage Doors pros!
As time passes, your garage door track will wear out and get damaged. Sad to say, that is a common problem and one you should avoid. You surely do not want to find yourself in a situation where you are stuck inside or outside your garage, unable to close it. The good news is that there are easy fixes when this issue happens to your door.
It is a good idea to familiarize yourself with adjusting your garage door tracks regularly. Adjusting the tracks is easy and takes only a few minutes, so it is a good habit to get in to avoid potential problems that can arise. There are signs that the tracks require your attention.
• The door seems crooked or off-balance
• The door struggles to open and close because it is binding
• The door starts to rub against its rubber molding
Tools you will need:
Check the Springs and Cables on Your Door
It is important to regularly check your garage door's springs and cables for any damage or wear. These parts are under a lot of tension and can be dangerous to replace, so it is best to call a professional garage door repair service if you notice any issues.
Inspect Your Garage Door Tracks
Check your garage door tracks for signs of wear and tear or potential obstructions. A repair professional can help you with any replacement needs. To clean the tracks, use a clean cloth or compressed air. Do not grease the track afterward, as this can cause the rollers to slip and the door to not open or close properly.
Readjust the Position of Your Door's Track
After you have loosened the screws attaching the door's track to the wall, give the bottom of the track a few taps with a rubber mallet. That will help get it into position. Then use a level to ensure the track is straight up and down. Once it is level, tighten the screws again. Repeat these steps on the other side.
Fill the Gap
A garage door that rubs against the molding or has a gap can be more than just an annoyance — it can also be dangerous. These problems can lead to serious issues. That is why taking care of them as soon as possible is important.
To remove the gap between a door and molding:
• Begin by loosening the bolts that hold the track in place.
• Move the track until there is only a 1/4- inch gap or less between the door and molding.
• Tighten the track and check to make sure it is secure.
Do you feel your door rubbing or binding when you open or close it? Turn to us to fix the problem! Fixxed Garage Doors is the leading name in providing top-quality garage door services in Studio City and Burbank, CA. We have highly qualified, trained, and certified technicians to handle garage door repairs in your homes and commercial places. Our professionals use highly durable parts, tools, and technologies to ensure your garage door functions as it should. Call us today or visit our website for more information.
Looking for a garage door service in Burbank, CA? Trust Fixxed...
See our most recent garage door opener installation for a North...
We did a cable replacement for a homeowner in North Hollywood,...
Fixxed Garage Doors https://www.fixxedgaragedoors.com/ (323) 364-6764 Open 24 Hours / 7 Days a Week Facebook